Stake additional points

Use the Additional points method to stake design features that are not part of the road design file, such as key positions for a drainage system, lamp posts, or road signs, without having to leave the Roads app and switch to General Survey. Additional points provide station and offset details from the primary alignment or string.

During stake out, you can stake additional points as needed. Tap any point in the job or tap a point in any kind of linked file, including DXF, BIM, or CSV.

1. In the stakeout selection screen:

   • When staking from a road design file, tap the additional point in the map.

   • When staking strings and surfaces, select Additional points in the Stake field and then tap the additional point in the map.

   The selected point is automatically copied to the job.

2. If required, add the following features:
   • To set stakes offset from the road, leaving the roadway clear for construction, define a construction offset.
   • To confirm the construction of the road surface, define a cross slope.

3. Tap Start.

   The Road navigation screen appears. Tap Options to configure preferences for the navigation display, grade, as-staked point details, or to view stakeout deltas relative to a digital terrain model (DTM).

4. Use the information in the Road navigation screen to see your position relative to the road and navigate to the point to stake it out.
5. To edit the Design elevation, press the Space key or tap next to the Design elevation delta and enter the new value. The original design elevation is automatically restored as soon as you change the design or the section of the design being staked, or once you exit stakeout. To restore the original elevation during stakeout after you have edited it, press the Space key or tap and then tap next to the Design elevation field and select Reload original elevation.

6. When the point is within tolerance, tap Measure to measure the point.

7. Tap Store.

   The software returns to the navigation screen.

Next steps

• To continue measuring points along the road, tap the Sta+ or Sta‑ softkey to select the next or previous station.

  If you have enabled the Auto increment field in the Select station screen then the next or previous station is automatically selected. See Stations available for stakeout.

• To change stakeout methods, and stake:
  • To the road, double-tap an empty part of the map.
  • To a string, tap the string in the map.
  • A Station on a string, tap the station on a string in the map.
• To exit this stakeout method, tap Esc.